Vertical QASM Adapter Kit

In stock
Only %1 left
STARTING AT $10.00
Item Description

The Vertical QASM Adapter Kit (VQA) was designed for plate carriers without vertical 1” buckles on the front plate bag for attachment of placards and chest rigs. The VQA mounts directly to the MOLLE/PALS channel on the front of the plate carrier enabling attachment of any Haley Strategic Chest Rig or Placard.

Note: Plate carriers that do not have a VELCRO® Brand loop panel on the front plate bag for attachment of the chest rig or placard will require a cummerbund connector kit. The Side Tension Strap Kit (STS) and AXL Chest Rig Retention Kit enable attachment of chest rigs and placards to plate carrier cummerbunds.

  • Made in the USA from USA materials (Berry Compliant)

Item Comes With

  • (2) Vertical QASM Adapters

Dimensions

  • 3.5” (L) x 1.5” (W) x 0.75” (H)

Construction

  • MIL-SPEC nylon webbing
  • 1" QASM Buckles (Female)

Product Care and Maintenance Nylon Products

CARE INSTRUCTIONS: Hand wash with warm water and a cloth or soft brush to remove dirt and debris, air dry indoors away from direct sunlight and do not store damp. DO NOT MACHINE WASH, MACHINE DRY OR DRY CLEAN. Exposure to detergents, bleach, or solvents may result in degradation and reduce the effectiveness of the product.

Product Liability Nylon Products

This manual should be read by all persons who have or will have the responsibility for using or maintaining this product. Any warranties by Haley Strategic Partners LLC with respect to this product are voided if the product is not used and maintained in accordance with the instructions in this manual. The following are general safety warnings intended to call attention to the fundamental performance limitations and areas of the product where proper usage must be followed. Failure to use and maintain the product according to the instructions and warnings contained herein may result in the product failing to perform as designed.

FAILURE TO COMPLY WITH ANY OF THE INSTRUCTIONS OR WARNINGS WILL RESULT IN FAILURE, WHICH SUCH FAILURE MAY RESULT IN SERIOUS INJURY OR DEATH

  • Inspect the product for discoloration, chemical contamination, excessive UV light exposure, cuts, tears, damaged threads/bartacks, abrasions or cracks before and after each use. If the product fails inspection, it must be destroyed or repaired by the manufacturer before further use.
  • DO NOT alter the product in any way
  • DO NOT repair the product in any way
  • DO NOT expose the product to open flame or excessive heat (this product is not flame resistant)
  • DO NOT use this product except in its intended manner

Product Warranty Nylon Products

If a defect in materials or workmanship is found in any of our nylon products, we will repair or replace it, free of charge. This excludes normal wear and tear. Products that we carry that are made by another manufacturer, such as North American Rescue, AXL, SOAR and others are subject to the warranty and service policies of those manufacturers. Be aware that the customer is responsible for any and all return shipping charges. This warranty applies to the original purchaser and is non-transferrable. Proof of purchase will be required.

  • Normal use allows for a 3-year life of this product, due to natural degradation of materials, if this product is 7-years old it should be destroyed (even if unused)
  • All replacement parts must be acquired from Haley Strategic Partners LLC or a licensed dealer partner

California Prop 65 Warning

PROP 65 WARNING: This product contains chemicals known to the State of California to cause cancer and birth defects or other reproductive harm.